Search Brinlay
News & Projects
- Brinlays'new Stain Sealer a HUGE SUCCESS !!
Brinlays' New "Stain-Cover"is causing a lot of excitement!
Trade painters are switching over from the expensive alternative in a BIG way after trying it only once!- APAS - Australian Paint Approval Scheme - What this means to you, our customer!
- APAS - Australian Paint Approval Scheme - What this means to you, our customer!
This is a set of PAINT STANDARDS issued by the Federal Government and administered by the CSIRO. - OUR NEW BLACKTOWN STORE
- Our newest large format store opened in early 2010 at 178 to 180 Main St Blacktown and has proven to be very popular with Trade Painters and DIY customers alike,
Interior
Exterior
Varnishes
Sealers
Trim Colours
Wood Stains
Premium Galvanised Zincalume Primer
This water based primer is designed to have excellent adhesion to galvanised iron and zincalume. It dries rapidly to a smooth, flat finish which may be over-coated with either enamel or acrylic finishes. It may be tinted using Universal Colourants.
It is recommended for use on all new and slightly weathered galvanised surfaces, and may be used on properly prepared aluminium. It is not suitable for use on rusted galvanised iron. It is essential that galvanised iron and zincalume surfaces be degreased before painting.
SURFACE PREPARATION
All surfaces to be painted must be thoroughly dry, clean and free from dust, grease and other contamination. Where mould is present, the surfaces must be treated with an algaecide. Kalsomine or powdery surfaces must be thoroughly rubbed down until all powder is removed. In severe cases, surfaces should be treated with Brinlay Surface Binder and Conditioner before undercoating.
APPLICATION AND CLEAN UP
Stir well before use with a broad paddle. May be applied with a brush, roller or spray direct from the can. Clean up with water and detergent.
DRYING AND RECOATING
Touch dry in 30 minutes, recoat after approximately 2 hours. In low temperature conditions or in damp humid weather, drying times may be extended. Do not apply if the temperature is below 10ºC or if it is likely that the temperature will fall below this level during the drying period.
COVERAGE
Will cover approximately 14 square metres per litre. On rough or absorbent surfaces this will be reduced.
SAFETY
Provide adequate ventilation during application and drying. Keep out of reach of children. Do not dispose of waste paint or cleaning effluent through the drain. Keep in sealed containers for disposal in accordance with local regulations.
If Swallowed: Drink plenty of water and seek medical advice.
Eye Contact: Rinse with running water. Seek medical advice if irritation persists.