Search Brinlay
News & Projects
Consectetuer
sem ac pede gravida sagittis. Sed et felis. Vestibulum placerat, ipsum nec congue auctor, ante massa placerat felis, sit amet consectetuer elit arcu vitae metus...Read More
Vitae Metus
sem ac pede gravida sagittis. Sed et felis. Vestibulum placerat, ipsum nec congue auctor, ante massa placerat felis, sit amet consectetuer elit arcu vitae metus...Read More
Interior
Exterior
Varnishes
Sealers
Trim Colours
Wood Stains
Contractor's Choice Wall & Ceiling White
DESCRIPTION
A cost effective, easy to apply flat plastic with good opacity for ceilings and walls .
SUITABLE PAINTING SURFACES
All interior ceilings and walls where an ultra flat finish is required.
GENERAL DATA
Gloss Selection Guide (when viewing at 60º angle to surface)
Approximately 0 – 1% at 60°
Colour: Can be tinted to a wide range of colours from a white base.
Application: Brush, roller or spray. Provide adequate ventilation. Temperature should be above 10ºC. Early exposure to steam, overnight dew, rain or hosing may result in damage or removal of the coating.
Coverage: Approx. 14 sq. metres per litre.
Thinning: Up to 100ml of clean water per litre for spraying or application to very porous surfaces.
Drying: Touch dry in 30 minutes. Recoat 2 hours on a day of 25ºC and 50% relative humidity, but will be longer in adverse conditions.
Clean Up: Water and detergent. Dried spots can be removed using Brinlay General Purpose
Thinners.
SURFACE PREPARATION
- Previously painted surfaces:
Ensure all surfaces are cleaned of dirt, dust, powder, grease, oil, smoke stains, cooking residues, polishes and materials detrimental to the finish and adhesion of the new paints by washing with water and detergent or sugar soap (as appropriate), rinse clean any residues. - Sterilise mould or moss with bleach or Brinlay Fungicidal Wash.
- Fill surface holes with an appropriate filler and sand to match existing surface. Sand all gloss and semi gloss paints to a flat look. Remove flaked, cracked, peeling and poorly adhered unsound paints which should be tested as follows:
- Test surface at random by cutting a small cross (X) through the existing paints. Apply and press down firmly a piece of sticky tape over the cut. Hold the end of the tape and rip off. If the paint is removed, check other areas. Paints consistently failing test or, if any doubt to their adhesion, should be completely removed.
- Powdering paints should be washed down with sugar soap and have one coat of Brinlay Binder & Conditioner applied.
- Poor surfaces or dark colours should be undercoated with Contractors Choice Acrylic Sealer Undercoat before application of Contractors Choice Wall and Ceiling.
New Interior Surfaces (Plasterboard):
Apply one coat Contractors Choice Acrylic Sealer Undercoat. Finish with 1 – 2 coats Contractors Choice Wall and Ceiling.
HEALTH AND SAFETY
For detailed information, refer to the product label and the current Material Safety Data Sheet available through Brinlay Paints.
Flammability: This product is non-flammable. Store and use away from sources of heat and ignition.
Toxicity: Non-toxic, environmentally friendly, lead free and non-hazardous.
TRANSPORT AND STORAGE
Sizes: |
4 litre, 10 litre, 15 litre, 20 litre |
Dangerous Goods Class: |
N/A |
Flashpoint: |
N/A |
UN: |
N/A |
Packaging Group: |
N/A |