BRINLAY PAINTS Head Office
65 Waratah Street
Kirrawee NSW 2232
Ph: 02 9521 8777
Fax: 02 9521 4797
News & Projects
- BRINLAYS' PAVING ENAMEL- YOUR H/DUTY SOLUTION!!
Brinlay Paints has re-launched its Heavy Duty Paving Enamel,this "Urethane Enriched"
formula is a FAST DRYING coating for interior & exterior situations
- FLOORSHINE-Heavy Duty,High Traffic protection for timber!
DO you need heavy duty protection for timber floors,staircases and timber bench tops?
Then you need Brinlays' "FLOORSHINE" Its' tough, high film build formulation is HIGHLY SCRATCH RESISTANT.
- "SILVER COAT"FOR ALL OF YOUR METAL SURFACES
- "SILVER COAT" could be the perfect solution for your metal surfaces!!
If you have a problem finding a tough durable coating for your roof,wrought iron doors, fencing,railings, table settings or general metal surfaces outside,"SILVER COAT" is ideal.
Stonewash is a distinctly different flat finish that provides a sandstone type texture, which is subtle, but still able to hide most surface imperfections. Stonewash gives a uniform flat finish which will not discolour, blotch, mottle or powder; which means it can be easily re-coated without the use of expensive “binder sealers” which are required on many other flat finishes. Stonewash may be used internally and externally, and is expected to have a life of 10 years plus.
SUITABLE PAINTING SURFACES
Stonewash is suitable for use on new; cement render, concrete, brick and fibro surfaces. It may also be used over a previously painted surface, where an acrylic paint was used and correct preparation is given. Stonewash is not recommended for use on timber or metal surfaces.
Selection Guide (when viewing at 60º angle to surface)
Approximately 5 – 10% at 60°
Colour: Tinted to a full range of colours from an extensive range of white and coloured bases.
Application: Use product direct from can, only thin as required. Stonewash may be applied by brush or roller. Due to high solids in this product, it will form a dry film faster than conventional paints and must therefore be applied in a way to compensate for this and to ensure a wet working edge is maintained. The method recommended is the same as that used for textured paints.
Two even coats should be applied to the surface. Never paint when the temperature is below 10° celsius or above 30° celsius, or in extreme humidity.
Coverage: 8-10 square meters per litre per coat. This may vary, depending on the surface.
Thinning: Water – only thin as required.
Drying: Recoat 4 hours on a day of 25ºC and 50% relative humidity, but will be longer in adverse conditions.
Clean Up: Brushes and rollers clean up in water.
The surface must be sound and free of dirt, mould, moss, grease, oil, flaky or powdery paints and any other contaminant which may affect adhesion to the surface.
On new surfaces, a 100% Acrylic Sealer is recommended as a first coat to seal the surface. This will prevent the Stonewash from absorbing into the surface and drying too quickly for the applicator to maintain a wet edge.
HEALTH AND SAFETY
For detailed information, refer to the product label and the current Material Safety Data Sheet available through Brinlay Paints.
Flammability: This product is non-flammable. Store and use away from sources of heat and ignition.
Toxicity: Non-toxic, environmentally friendly, lead free and non-hazardous.
TRANSPORT AND STORAGE
4 litre and 15 litre
Dangerous Goods Class: